Marine Grade Protection / IPX Rating
Amplifiers are ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
Low Noise Preamplifier Circuit
Low Noise Pre-Amplifier Stage: Special preamplifier reduces incoming noise from source units dramatically improving sound quality.
RCA Inputs
2 Pair, RCA Nickel-Plated: High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant.
Operation Mode
Four channel operation: Flexible installation allows this amplifier to run in four channel or bridged mono mode.
Crossover Type
Switched OFF/HP: Complete control of amplifier signal, essential when using two or more amplifiers.
Class / Topology
Full Range Class D: Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
Output Device Technology
PWM MOSFET Power Supply: Stable power through the PC board with minimal heat generation.
Heat Sink
Aluminum: Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration.
Power Supply
Simpatico Coil Design: The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices.
Output Connections
Quick Dissconect Wires, RCA Connections: Quickly remove amplifer when you are putting machine up for the winter of as a security precaution.
Connection Type
Nickel plated corrosion resistant connections.
LED System Protection Circuitry Diagnostics
Three-stage protection circuits: Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel.
Additional Features
Marinized/Waterproof: Water resistant for durability in any environment.
