Banks Power® 49789-B

4 inch heavy-duty stainless DPF-back Monster Exhaust system with constant-diameter intermediate pipe and tailpipe. Exclusive CoolCuff design lowers tailpipe temperatures as much or more than stock while dramatically increasing flow and cutting backpressure. Tested and refined by Banks engineers using Computational Flow Dynamics software, then validated through extensive temperature testing in all areas: before and after the DPF, 6 inch out from the tip, by the spare tire, shocks, wiring, hoses, and more. The system safely clears the spare tire, shocks and brake lines, and includes a huge 6 X 5 inch ob-round (patented design) angle-cut rolled-edge tailpipe tip in your choice of polished chrome-over stainless or high-temp black! And to help keep them looking good, there's 1/2 inch air gaps to keep heat from tarnishing the finish. Adjustable clamps let you position them on the tailpipes just right. Please Note: These exhaust systems do not fit Cab/Chassis models. Banks Monster Exhaust for the 6.7L is available in the following configurations: Side Single. Side Duals. Flows up to 80% better than stock! Cooling as much or more than stock without killing flow is a major challenge. But Monster Exhaust wins on both counts and increases fuel efficiency in the process. Testing and Validation - Computational Fluid Dynamics (CFD) software: That's the Banks difference. Our engineers input active regeneration DPF outlet temperatures into the computer, then run flow dynamics analysis to show the cooling effect of the CoolCuff design all along the flow path. Banks Has the Solution. Engineered CoolCuff design. The diesel particulate filter (DPF) reduces smoke by turning it to ash through regeneration. This can heat exhaust gas temps to 1,100 degrees at the DPF outlet! Banks Monster Exhaust with CoolCuff reduces these dangerous temps as much as or more than stock while also cutting backpressure and improving fuel economy. Full overview