POISON SPYDER® 17-16-021-DBP1

Poison Spyder BFH front bumper is designed for those hardcore four-wheelers who value strength, simplicity and function. This bumper was literally "Built For the Hammers" with the best ground clearance, tire clearance and approach angle possible. It is just slightly wider than the Jeep's frame rails, with angled facets to improve its ability to slide over the rocks. The BFH II bumper is CNC laser-cut from high strength 3/16" plate steel, then precision brake-formed for an exact fit. The BFH II bumper features a DOM tube, gusseted Brawler Bar, integrated winch mount, and provisions for mounting the OEM Jeep fog lights. Finished in Poison Spyder's SpyderShell semi-gloss black coating.The Brawler Bar is a low-profile Stinger, fashioned after the 2-bend Stinger featured on our original RockBrawler bumper for JK. The Brawler Bar features the most versatile combination of trail protection and a lower profile for easier access to the winch and engine compartment, fitment into garages and trailers, etc. Plus it looks bad-ass! The Brawler Bar ar is fabricated from 1-" DOM tubing. The tubes are CNC laser notched to seat onto two different surface planes of the bumper shell for maximum strength, then further strengthened with CNC laser cut 3/16" plate steel gussets. The rake of the Brawler Bar matches the angle of the front surface of the bumper, to provide an un-hindered "ramp" if needed, to help the vehicle up onto extreme obstacles. The Brawler Bar extends 7.4" forward from the front edge of the bumper, and 9.8" high from the top surface of the bumper.